(THIS IS NOT THE MOST CURRENT VERSION. SEE 3D PRINTING PAGE)

Here is a quick disconnect mount for the X-CARVE that holds the laser and the driver.

VERSION 5

MY JTECH MOUNT BASED OFF OF THE SHANE BELL DESIGN

Overall dimensions of main bracket

​4.06" wide x 2.48" deep x 6.77" tall

(THIS IS NOT THE MOST CURRENT VERSION. SEE 3D PRINTING PAGE)

(THIS IS NOT THE MOST CURRENT VERSION. SEE 3D PRINTING PAGE)

3D printed version printed by LarryM

CHANGE NOTES:

  • Added bracing for strength
  • changed right Dewalt catch profile
  • increased slop for shield insertion
  • on shield, increased glass rim
  • increased port insert slop
  • completely changed port adaptor and port system. now uses parts that can be connected end to end.

DESIGNS BY PHIL, LLC

(THIS IS NOT THE MOST CURRENT VERSION. SEE 3D PRINTING PAGE)

ADDED 12/14/2017

ADDED 10/4/2017

It was brought to my attention that the shield would be too close on the stock x carve z axis so use version 6

THE 3D PRINTED VERSION

Here is a quick disconnect mount for the X-CARVE that holds the laser and the driver.

THE BENT ALUMINUM VERSION

ADDED 1/8/2018

VERSION 2

This section is for the older designs of the Jtech mount for the X-Carve. They are out of date and not the current design. For reference only.

Older Jtech Mount Versions

(THIS IS NOT THE MOST CURRENT VERSION. SEE 3D PRINTING PAGE)

MY JTECH MOUNT BASED OFF OF THE SHANE BELL DESIGN

(THIS IS NOT THE MOST CURRENT VERSION. SEE 3D PRINTING PAGE)

ADDED 12/13/2017

Suggested orientation on build plate

    Here is a quick disconnect mount for the X-CARVE that holds the laser and the driver and has a removable shield with fume extractor port

    Here is a quick disconnect mount for the X-CARVE that holds the laser and the driver and has a removeable shield with fume extractor port

    MY JTECH MOUNT BASED OFF OF THE SHANE BELL DESIGN

    MY JTECH MOUNT BASED OFF OF THE SHANE BELL DESIGN

    Laser proof acrylic should be 1.625" x 3.625" x .185" thick

    VERSION 3

    VERSION 4

    Overall dimensions of shield

    ​2.69" wide x 2.81" deep x 4.00" tall

    (THIS IS NOT THE MOST CURRENT VERSION. SEE 3D PRINTING PAGE)

    MY JTECH MOUNT BASED OFF OF THE SHANE BELL DESIGN