DESIGNS BY PHIL, LLC

END MILLS

My Other Vcarve Tool Settings

*

(One thing to note, the pictures are not always correct on Amazon, but the part numbers are)

Engraving bits. Good for edge lit acrylic signs
Carbide PCB Engraving CNC Bit Router Tool 30 Degree 0.1mm Pack Of 10


Feed rate: 90ipm
Plunge rate: 30ipm
Step over: 60%
Specified bit diameter in Easel: .015"

3/4" DIAMETER BITS

CNC BITS

*

*

1/4" DIAMETER BITS

*

If your V bit has a flat tip (and a lot do), this is how to set up the bits

3D MILLING BITS

1/2" DIAMETER BITS

*

OTHER MILLING BITS

*

This is a page with bits that can be used with the Dewalt 611 based CNC. I have not used all of these but I have used some. I fully support Whiteside bits. They are high quality and last a long time.

= BITS I OWN

*

*

*

1/8" DIAMETER BITS

My Vcarve Tool Settings

My Vcarve Tool Settings

V BITS

1/16" down spiral fishtail bit

My Vcarve Tool Settings

*

1/8" up spiral long reach bit

All Whiteside bits...

SH = Shank

CD = Cut Diameter

CL = Cut Length

1/16" DIAMETER BITS